Intex Quickfill Plus AP620D Bedienungsanleitung Seite 3

INFLATION
1. Open cord compartment cover and remove power cord. Do not yank on the cord.
See Fig (1).
2. Plug in the AC power cord into an AC electrical outlet. See Fig (2).
3. Turn the control dial fully clockwise until it stops. The pump turns on automatically to
inflate the air bed. See Fig (3).
4. When the air bed is fully inflated, turn the control dial back (counterclockwise) to the
center position which closes the valve and turns the pump off. See Fig (4).
NOTE: Turning the control dial either direction while the pump is unplugged will let air
escape from the air bed. See step #5 for firmness adjustment instructions.
Never disconnect the power cord from the electrical outlet while the pump is running. Rotate
control dial to the closed / pump off position before disconnecting the power cord.
5. If the air bed feels too firm, release some air by simply turning the control dial gradually
counterclockwise until air begins to escape from the air passage. When the desired
firmness is achieved, turn the control dial back to the center closed / pump off position.
If the air bed feels too soft, repeat steps #3 to #5 as necessary.
SAVE THESE INSTRUCTIONS
(17IO) AP620D/AP620DP ELECTRIC PUMP ENGLISH 4.875" X 7.25" 04/20/2023
FIG (1)
Rotate to Closed / Pump Off Position
Page 3
220 – 240 V
√
FIG (2)
Inflate
Position
FIG (3)
FIG (4)
17
IO
110 -120 V