Intex Quickfill Plus AP620D Bedienungsanleitung Seite 5

1. Open cord compartment cover and locate the
manual inflation port.
2. Make sure the control dial of the internal electric
pump is still in the closed / pump off position.
3. Remove the cap from the manual inflation port and
insert the nozzle of the pump into the port. Inflate the
air bed to desired firmness.
NOTE: Do not overinflate. The firmness should be
approximately the same as the level achieved with the
internal electric pump.
4. Remove nozzle from manual inflation port and
close the cap and the cord compartment cover.
STORAGE INSTRUCTIONS
1. Deflate the air bed following the "DEFLATION" instructions.
2. Make sure the air bed is clean and dry.
3. Lay the air bed flat with the sleeping surface facing upwards and follow the folding steps
on Figs (8 - 12). Fold the air bed loosely and avoid sharp bends, corners and creases
which can damage the air bed.
FIG (8)
REPLACING INTERNAL AIR PUMP OR THE AIR BED COMPONENT
If there is a need to replace either the internal air pump or the air bed portion, detach the
internal pump from the air bed as follows:
1. While holding both lock tabs pressed inward (see Figure 13), turn the round body of the
pump (the large outer rim, not the control dial) counterclockwise and pull the air pump
body out of the holder frame.
2. Depending on which part is being replaced, keep the remaining component (either the
air bed portion or the removed pump) in a safe place until the replacement part is
received. Reattach the components when the new part is received: simply place
the pump into the holder frame and turn clockwise untill the lock tabs click into place.
NOTE: Make sure the rubber seal on the pump housing as well as the inside wall of the
holder frame are clean and free from any lint, hair or dirt, to ensure a proper seal and avoid
air leaks.
NOTE: Do not remove internal air pump from the holder frame other than for servicing, as
this may introduce lint, hair or dirt into the seal area and cause air leaks. If air leak is
experienced, check that the seal is clean before replacing the pump or the air bed.
SAVE THESE INSTRUCTIONS
(17IO) AP620D/AP620DP ELECTRIC PUMP ENGLISH 4.875" X 7.25" 04/20/2023
FIG (10)
FIG (9)
1
2
Page 5
FIG (11)
1
FIG (13)
17
IO
FIG (7)
FIG (12)