Unitec Climate W193 Bedienungsanleitung Seite 9

SUNNY PARTLY CLOUDY
WEATHER FORECAST
The unit predicts weather condition of the next
12 – 24 hours based on the change of atmospheric
pressure. The coverage area is around 30 – 50
km. The weather forecast is based on atmospheric
pressure change and is about 70 – 75% correct.
As weather conditions cannot be 100% correctly
forecasted, we cannot be responsible for any loss
caused by an incorrect forecast.
To obtain an accurate weather forecast, you need
to input your current weather condition as initial
setting. After the reset of the unit, Press [UP] ² or
[DOWN] to select the local weather condition as
initial weather forecast setting. Press [CLOCK]
confirm and exit.
You may also set the weather forecast by holding
[CLOCK] button to enter the setting mode. Press
[CLOCK] repeatedly to skip the clock & calendar
setting until the weather icon flashes. Press [UP] ²
or [DOWN] to select local weather condition.
Press [CLOCK] to confirm and exit.
12/24hr format > Hr > Min > Yr > D/M or M/D
format > Month > Date > Weather Forecast > EXIT
NOTE
Different geographical location such as inland area
or coastal region has different weather forecasting
response. In case your weather forecast always
show rainy or stormy over a long period of time and
does not reflect the actual weather condition, it is
necessary to follow above setting procedure for fine
tuning the weather forecast's accuracy
RADIO-CONTROLLED CLOCK
The unit will start synchronizing the clock after bat-
tery/adapter ¹ installation or reset. In normal mode,
press [ /UP] ² until
icon (A) appears to enforce
searching of radio-controlled clock signal. If the icon
(A) disappears afterwards, radio time signal is not
available at the moment. Try other locations later.
Place the unit away from source of interference such
as mobile phones, appliances, TV etc.
313508_W193_Manual_130215.indd 9
All manuals and user guides at all-guides.com
CLOUDY
Antenna icon (A) with full signal strength
appear on screen if the reception of radio-controlled
time is successful. The radio-controlled clock will
have a daily synchronization at around 02:03 and
03:03 everyday. Each reception cycle is minimum
2.5 minutes and maximum 10 minutes.
IN/OUT TEMPERATURE & HUMIDITY
Temperature reading (D) is located on the lower left
of the display and humidity (E) is on the lower right.
Press [C/F]
Press [SNOOZE/CHANNEL/LIGHT]
to
select indoor, Ch1, Ch2, Ch3 and auto-channel scrol-
ling
COLOR BAR GRAPHS
The color graphs (G) are designed as an intuitive
way to gauge the weather at a glance.
The left color bar graph represents the respective
In/Out temperature of the current display mode.
The right graph represents the respective In/Out
humidity. As the measurements change, the number
of illuminated bars changes automatically.
MAXIMUM / MINIMUM MEMORY
Press [MEM]
mum & minimum values of temperature & humidity
readings. To clear the memory record, hold [MEM]
on screen.
TEMPERATURE & HUMIDITY TREND
INDICATOR
The icons will indicate Rising, Steady, Falling if the
temperature or humidity change is more than 1
degree C (or 2 degree F) within an hour.
9
RAINY
button to select temperature unit C/F.
display modes.
button repeatedly to view the maxi-
button while the respective values are displaying
STORMY
will
button to
English
27.02.13 12:49