AEG FT 4925 Bedienungsanleitung Seite 79

4) When the measured temperature exceeds 38.0°C the thermometer will
send out "Beep-Beep-Beep" a long one and two short ones, and the
display will show the icon of fever (Refer to the Picture 7.3).
Notes:
• Keep the probe surface clean, otherwise the measurement can't be
accurate.
• Clean the probe with clean cloth or paper moistened with water or
alcohol, and conduct measurement after the water on the surface of
the probe all evaporates.
Taking Temperature in Forehead Temperature Mode
1) When the system is in the state of time / environmental
temperature display, press the button of scan, and the last
temperature reading will be displayed. Then, the system will go
"Beep-Beep" and enter into the mode of measurement (Refer
to the Picture 8.1-8.3).
2) Make sure the probe cap is on. Press the probe of the
thermometer directly on the forehead.
3) Press the Scan button. One second later you will hear
"Beep",and you can remove the thermometer. The meas-
urement is completed.
4) When the measured temperature exceeds 38.0°C, the
thermometer will send out "Beep—Beep-Beep", a long
one and two short ones, and the display will show the
icon of fever (Refer to the Picture 8.4).
English
79
(Picture 8.1)
(Picture 8.2)
(Picture 8.3)
(Picture 8.4)