To Mount The Unit - Daikin LMS Serie Installationsanleitung

5 Installation
In case of "wall mounting" method
In case of wall mounting method (see "5.4.2 To prepare the cold
room" [ 4 11]), the optional insulation pad must be installed on the
unit. Refer to the installation instruction included in the insulation pad
option.
1 Install the insulation pad (a) at the back of the unit condenser
by sliding it in place.
2 Install the screws (d), the flat washers (b) and the spring
washers (c) through the holes on the back of the insulation pad
(a) and so in to the back panel of the unit condenser.
3 Tighten the screws (d) to the point that the spring washer (c) is
flattened.
1
a
a Insulation pad
b Flat washer
c Spring washer
d Screw
4 Install the self-adhesive gasket (e) against the back panel (f) of
the unit condenser all around the insulation pad (a).
a f
a Insulation pad
e Gasket
f Back panel
5 The unit can now be positioned in front of the cold room wall for
installation.
KG
Installation manual
12
2
b c d
a e f
In case of "saddle mounting" method.
In case of saddle mounting method (see "5.4.2 To prepare the cold
room" [ 4 11]), the unit can now be positioned in front of the cold room
wall for installation.
KG
5.4.4

To mount the unit

INFORMATION
Use a lifting table and straps that can bear the weight, see
"10 Technical data" [ 4 27] for the weight of the unit.
In case of "wall mounting" method
1 If not already done, position the unit on a lifting table and
secure it with straps, see "5.4.3 To prepare the unit" [ 4 11].
2 Position the unit (a), with the insulation pad (b) in place, in front
of the cold room cutout (c).
3 Slide the unit through the cutout.
a b
a Unit
b Insulation pad
c Cutout
c
LMSEY1A09/13 + LMSEY2A19/25
Daikin LMS
4P728170-1B – 2023.07