AEG HSM/R 5673 NE Bedienungsanleitung, Garantie Seite 50

English
50
NOTE:
Start by using the biggest comb attachment and cut your hair/beard step by step to the
desired length.
Outlining and Shaving the Neck
• The clipper head allows precise outlining the shape of the beard, even in difficult to
reach places as well as a clean shaving of the hairline at the neck.
• Turn the device off with the switch.
• Remove the cutting length comb and turn the hair clipper on again.
Finish Operation
• Switch off the appliance. "OFF" can be seen on the switch.
Nose / ear hair trimmer
CAUTION:
• The precision engineered shaving head must not be subjected to strong loads and
impacts etc.
• Do not insert any sharp objects into the shaving head.
Installing the nose / ear hair trimmer attachment
1. Turn off the device. "OFF" can be seen on the switch.
2. If necessary, remove the shaving head as described under "Cleaning and Mainte-
nance".
3. Push the nose / ear hair trimmer attachment onto the housing from above. Please note
that the white drive shaft must sit on the brass-colored motor driver.
Use
• Switch the device on. "ON" can be seen on the switch. The indicator lamp lights up
green during battery operation.
• Move the top of the shaving head towards the nostril or outer ear.
WARNING:
Only remove hair protruding from the nostril / outer ear. Do not forcibly push the
appliance into the nostril / outer ear. There is a risk of injury if the shaving head is
inserted too far!