Care & Maintenance - Xiaomi X10 Benutzerhandbuch

Empty the Dust Compartment
When the robot vacuum has finished a cleaning task, it will return to the auto-
empty station to charge. The auto-empty station will then automatically start
to empty the dust compartment. You can go to the app to enable or disable the
auto-empty function and modify the auto-empty frequency as needed.
Resume Cleanup
If the robot vacuum starts running low on battery during a cleaning task, it will
automatically return to the auto-empty station to recharge, then resume cleanup
where it left off after being charged sufficiently.
Pause
While the robot vacuum is running, press any button on the robot vacuum to
pause it, and then press the button to resume the cleaning. Pressing the
button will end the current cleaning task and send the robot vacuum back to
the auto-empty station.
Note: Do not pick up or move the robot vacuum while it is paused, so as to avoid navigation
errors that could prevent the robot vacuum from returning to the auto-empty station or cause
the loss of map.
Sleep Mode
The robot vacuum will automatically enter sleep mode after it is paused for 10
minutes, and its indicator will go out. To wake it up, press any button on the
robot vacuum.
Note: If the sleep time exceeds 12 hours, the robot vacuum will be turned off automatically.
11
Update the Firmware
You can update the firmware via the app. Before updating, make sure the robot
vacuum is on the auto-empty station and has at least 15% battery left.
Restart the Robot Vacuum
If the robot vacuum stops responding or cannot be turned off, press and hold the
button for 15 seconds to forcefully turn it off. Then press and hold the button
for 3 seconds to turn the robot vacuum on.
Restore Factory Settings
If the robot vacuum does not function properly after being restarted, you can
use a pin to press the reset button until you hear a voice to indicate that the
robot vacuum is restoring factory settings. This will reset the robot vacuum to its
original factory settings.
Care & Maintenance
Brush and Side Brush
* It is recommended to clean every two weeks.
1. Flip the robot vacuum over and pinch the clips to remove the brush cover.
2. Lift the brush out of the robot vacuum, then clean the brush bearings.
3. Use the included cleaning tool to cut any tangled hairs on the brush, and
remove the hairs and other debris from the brush.
4. Remove the side brush upwards to clean it.
5. Reinstall the brush, the side brush and the brush cover, and ensure they are
securely in place.
Notes:
· It is recommended to replace the brush every 6–12 months for optimal cleaning performance.
· It is recommended to replace the side brush every 3–6 months for optimal cleaning performance.
Brush Cover
Clip
Brush
Brush Bearings
Cleaning Tool
CAUTION: If too much hair is tangled in the brush, or if the hair is tightly tangled, do not forcibly
pull on it, as this could damage the brush.
Omnidirectional Wheel
* Clean it as needed.
1. Flip the robot vacuum over and pull out Wheel
the omnidirectional wheel.
Axle
2. Remove hair, dirt, and other debris from
the wheel and axle.
3. Reinsert the wheel and press it firmly
back into place.
Notes:
· A small screwdriver or other pry tool can be used to gently pop out and remove the wheel.
· The wheel can be cleaned with water and reinstalled after drying.
Disposable Bag
* Replace as needed.
1. Open the cover of the auto-empty station, pull the handle upwards to remove
it, and then discard the bag.
Note: Pulling upwards on the handle will seal the bag to prevent the dust and debris from
accidentally falling out.
12