Antenna Connection - PNI ESCORT HP 7110 Benutzerhandbuch

EN
DISPLAY
1 - Selected channel
2 - AM/FM mode
3 - RX/TX: reception (RX) and trasmission (TX) indicator
4 - SC: SCAN function activated
5 - AQ: automatic squelch activated
6 - R: RF GAIN activated
7 - Received signal strenght indicator and trasmission power signal
INSTALLATION
Check the radio and all accessories before installing.
Power the radio with the cigarette lighter plug included in the package. The radio must be powered
at a voltage between 12 - 13.2V. The fuse mounted on the power cord protects the radio against
damage caused by technical defects or wrong polarity. If the fuse is blown, first eliminate the cause
and then replace it using the F3A 250V type.
Check the connections correctly before starting the radio. Make sure there is no risk of shortcircuit.
Operation with AC Adapter
Operate your radio only at a stabilized radio power supply, which is capable to provi-de at least 2A
at 12 -13.2V DC. Unregulated power supplies or battery chargers are unsuitable and can cause
damage. Connect the red lead to the positive (+) terminal of the power supply, the black wire to the
negative (-) terminal of the power supply.

ANTENNA CONNECTION

Connect the CB antenna to the ANT socket on the back of your radio. The antenna must be tuned
to the CB radio band. For this use a SWR meter. For a good radio range, the SWR should not
exceed a value of 2. A high SWR also points to defects in antenna, cable, or a short circuit in the
antenna line. Never transmit without connected antenna!.
Note: The radio antenna is to be mounted from other antennas and interference sources as much as
possible. CB antennas must be mounted usually in the vehicule highest part on a metal surfaces.
A sufficiently large metal surface is essential for the function of the antenna. For installation on a
fiberglass cabs or plastic wind deflectors, special ground less antennas can be used.
OPERATION
Power On/Off the radio: Turn the radio on by turning the knob [6] clockwise. The current
•
standard, then the selected channel, will appear on the screen for one second. Turn knob [6]
anti-clockwise to stop the radio.
Note: The radio is preset from the factory on Channel 22, the CE standard.
5
TX AQ
3
RX
1 3 5 7 9 +30
7
4
2
FM AM
M H
6
SC R
1 4