Inspecting the circular saw blade
•
Check the circular saw blade carefully for
cracks or damage before and after each use.
Replace a cracked or damaged circular saw
blade immediately.
•
Replace with a new circular saw blade as soon
as it no longer cuts effectively. Continuing to
use a dull circular saw blade may cause a danger-
ous kickback and/or motor overload.
•
Circular saw blades for metal cutter cannot be
re-sharpened.
Replacing carbon brushes
► Fig.15: 1. Limit mark
Check the carbon brushes regularly.
Replace them when they wear down to the limit mark.
Keep the carbon brushes clean and free to slip in the
holders. Both carbon brushes should be replaced at the
same time. Use only identical carbon brushes.
1.
Use a screwdriver to remove the brush holder
caps.
2.
Take out the worn carbon brushes, insert the new
ones and secure the brush holder caps.
► Fig.16: 1. Brush holder cap
3.
Insert the battery cartridge into the tool and break
in brushes by running tool with no load for about 1
minute.
4.
Check the tool while running and electric brake
operation when releasing the switch trigger. If electric
brake is not working well, ask your local Makita service
center for repair.
OPTIONAL
ACCESSORIES
CAUTION:
These accessories or attachments
are recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons. Only use accessory or attachment
for its stated purpose.
If you need any assistance for more details regard-
ing these accessories, ask your local Makita Service
Center.
•
Carbide-tipped circular saw blades
•
Rip fence (Guide rule)
•
Clamping screw
•
Hex wrench
•
Safety goggles
•
Makita genuine battery and charger
NOTE: Some items in the list may be included in the
tool package as standard accessories. They may
differ from country to country.
10 ENGLISH