General Description - Gewiss Chorus GW 10 753 Bedienungsanleitung

The Easy 6-channel push-button panel (flush-mounting) is a command device with 6 channels that can
be used on their own or combined, to perform the functions of ON/OFF, dimmer control, roller shutters
control, scene management, priority and timed controls on a KNX bus.
Each device has 3 tilting push-buttons (each managing two channels) and a temperature sensor.
The device is powered from the bus line, and each channel has two LEDs (amber/green) for night-time
localisation and display of the controlled load status. The push-button panel module is inside the standard
flush-mounting boxes, mounted on the Chorus range supports in the space taken up by three modules.
Each of the 6 channels of the push-button panel can be configured with the Easy
controller to carry out your choice of one of the following functions:
CYCLIC ON/OFF SWITCHOVER
With this function the electrical loads can be activated or deactivated like, for instance, of the lighting
devices connected to a KNX actuator. The push-button sends the ON and OFF commands alternately.
The status of the controlled actuator is signalled by the LED (amber/green) selected, according to
the indications given in the INDICATOR LIGHT paragraph.
FRONTS MANAGEMENT
With this function the electrical loads can be activated or deactivated like, for instance,
of the lighting devices connected to a KNX actuator.
The channel can be configured for:
• sending the ON command;
• sending the OFF command;
• sending the ON command when the push-button is pressed, and the OFF command
when it is released (ON/OFF);
• sending the OFF command when the push-button is pressed, and the ON command
when it is released (OFF/ON).
In this mode the device does not allow the automatic control of the signalling LEDs. Their
switching on can be associated with the contact status of an actuator by means of a special
status channel to be explicity selected in the function creating phase.
ON COMMAND WITH TIMER
With this function an electrical load can be activated connected to a KNX actuator, i.e. stair raiser
light, which automatically deactivates after the time set, parameterisable on the actuator. The
status of the controlled actuator is signalled by the LED (amber/green) selected, according to the
indications given in the INDICATOR LIGHT paragraph.

GENERAL DESCRIPTION

Briefly
Functions
17
E
N
G
L
I
S
H