Programming With The Easy Configurator - Gewiss Chorus GW 10 753 Bedienungsanleitung

PROGRAMMING WITH THE EASY CONFIGURATOR

Program the push-button panel module with the Easy controller (GW 90 837 / GW 90 838 / GW 90
840).
If this device is added as an expansion to a KNX system programmed with the Standard
Unit (GW 90 831), please contact the Gewiss SAT Technical Assistance Service.
Each of the 6 channels to be programmed can be selected, as you require:
• by pressing the push-button: this channel will then be highlighted on the list of
channels;
• directly from the list of channels.
The channel for the temperature sensor can be selected, as wanted:
• by keeping the physical address programming push-button pressed for at least 2
seconds: this channel will then be highlighted on the list of channels;
• directly from the list of channels.
When configuring with the Easy controller, the sending of the object is disabled by default
in order to avoid the value of the temperature measured being untimely sent to the bus.
Only after the physical address programming push-button has been pressed the first
time, for at least 2 seconds, will the periodical transmission begin (or according to the
change in temperature).
The functions can be created once the devices have been selected.
22