General Description - Gewiss Сhorus GW 10 784 Installationsanleitung

The 6-channel push-button panel with KNX 1-channel actuator (flush-mounting) is a command device
with 6 channels that can be used on their own or combined, to perform the functions of ON/OFF, dimmer
control, roller shutters control, scene management, priority and timed controls on a KNX BUS.
On the device there is a relay with a changeover contact for managing an On/Off actuator channel
that controls the connected load; the channel allows the implementation of on/off and timed
activations, scenes and forcing.
Each device has 3 tilting push-buttons (each of which manages two channels).
The device is powered from the BUS line, and each channel has two LEDs (amber/green) for night-
time localisation and display of the controlled load status.
The push-button panel module is inside the standard flush-mounting boxes, mounted on the Chorus
range supports in the space taken up by three modules.
Functions push-button panel section
Each of the 6 channels of the push-button panel is configured with the ETS software to create
one of the functions listed below.
Sequence of the fronts/commands:
- management of fronts with sending of commands (1 bit, 2 bit, 1 byte, 2 byte, 4 byte, 14 byte)
- management of fronts with sending of sequences (1 bit, 2 bit, 1 byte, 2 byte, 4 byte, 14 byte)
- up to 8 communication items and timed intervals
- management of brief/extended pressure
- channel enabling/blocking
Scenes:
- management of scenes with 1-byte items
- sending of scene storing commands
Priority commands:
- sending of priority commands
Roller shutters/curtain command:
- with single or double push-button
- with sending of the percentage position (0%-100%)
Dimmer command:
- with single or double push-button
- with stop telegram or cyclical send
- with sending of the light intensity value (0%-100%)
Control of the output LEDs:
- 5 lighting effects for each LED, and colour selection
- local actuator status signalling function
Switchover sequences:
- with 1-bit items on BUS (from 2 to 8)
Local actuator on/off command:
- with commands for on/off, stair raiser light, activation/deactivation delay, flashing, scene,
priority command or shutdown

GENERAL DESCRIPTION

Briefly
13
E
N
G
L
I
S
H