vipow BAT1140 Bedienungsanleitung Seite 14

Indicator Light Status Explanation
Power lamp
(Green)
Fault lamp
(Red)
Step 1 Lamp
(Yellow)
Step 2 Lamp
(Yellow)
Step 3 Lamp
(Yellow)
Step 4 Lamp
(Yellow)
Step 5 Lamp
(Yellow)
EN
Step 6 Lamp
(Yellow)
Step 7 Lamp
(Green)
Step 8 Lamp
(Green)
14
Instrukcja obsługi
Constant ON AC electricity connected
Constant ON: Battery Pole reverse connection, please
exchange, Pas & Neg.
Flickering: Battery voltage too low or too high, please
check If this Is a 12V battery.
Constant ON: Detect vulcanized battery. Maintenance
by pulsing current and voltage, once maintenance
finished, this process will be stopped automatically and
next Step Lamp ON.
Constant ON: Test If the battery can accept charge.
This Step prevents that charging proceeds with a defect
battery.
Constant ON: Charging with maximum current until
reach to approximately 80% capacity, then switch to
next Step.
Constant ON: Charging with declining current o
maximize up to 100% battery capacity.
Constant ON: Tests if the battery can hold charge.
If Fault Lamp (red) flickering, this battery can not hold
charge, then need to be replaced or select "Recond
Program" for recharging.
Constant ON: Select the Recond program to add the
Recond Step to the charging process. During the
Recond Step voltage increases to create controlled
gasing in the battery. Gasing mixes the battery acid and
gives back energy to the battery
Constant ON: Maintaining the battery voltage at maxi-
mum level by providing a Constant voltage charge; If
battery voltage is too low, restart charging cycle
Constant ON: Maintaining the battery at 95% - 100%
capacity if battery voltage is too low, restart charging
cycle.