vipow BAT1140 Bedienungsanleitung Seite 11

Connect & Disconnect charger to battery
WARNING: Please connect or disconnect charger to battery
acording to the request & sequence mentioned below.
Charging separated lead-acid battery:
1. Connect Red clamp or eyelet to Pos pole of battery (" + "),
Black clamp or eyelet to Neg pole of battery (" - ");
2. lnsert mains plug into AC source socket;
3. For disconnection, first of all pull out the mains plug from AC
source socket, then disconnect the clamps or eyelet from
battery pole.
Charging vehicle-mounted leadd-acid battery:
1. Connect the red clamp to the Pos pole of battery, black clamp
to the vehicle chassis and keep away from fuel pipe and bat
tery. (If battery's Pos pole grounded, then connect black clamp
to Neg pole, red clamp to vehicle chassis and keep away from
fuel pipe and battery)
2. Insert mains plug Into AC source socket;
3. Before disconnection, first of all pull out the mains plug from
AC source socket:
4. Then disconnect black clamp before red clamp.
(If battery's Pos pole grounded,then disconnect red clamp
before black clamp)
Connection Protection:
This function will protect
Battery and Charger from
been damaged if connecting
in wrong way.
Instrukcja obsługi
EN
11