Operation; Care And Storage; In The Event Of Problems - Beurer MG 120 Gebrauchsanleitung

6. Start-up
• Remove the packaging.
• Check the device, power supply and cables for damage.
• Connect the device to the mains power supply.
• Route the cable safely so that there is no risk of anyone tripping over it.

7. Operation

To start with, gently press the part of your body
you wish to massage against the massage device.
Then make sure that you are in a comfortable position
before gradually shifting your weight onto the massage
device.The massage must be pleasant and relaxing
at all times. Stop the massage or change your posi-
tion or the contact pressure if you find it is painful or
unpleasant.
• Do not force any part of your body, in particular your
fingers, between the rotating massage heads and
their mountings in the device.
• Switch on the massage device with - button. Press
the - button again to switch the device OFF.

8. Care and storage

Cleaning
First unplug the device and allow it to cool off. Then you can clean it with a cloth which is no more than lightly
moistened. You can also use a mild detergent.
WARNING
• Disconnect the device before cleaning it.
• Only clean the appliance in the manner specified. Fluid must never be allowed to enter into the
device or accessories.
• Do not use the device again until it is completely dry.
Storage
Keep the massage device in a cool and dry place where it is out of the reach of children. We recommend
storing the device in its original packaging.

9. In the event of problems

Problem
Massage heads
rotating at
reduced speed.
Massage heads
not moving.
Cause
The load on the massage
heads is too great.
Appliance not connected to
the power supply.
Overheating protection
tripped.
Neck massage
Remedy
Release the massage heads.
Connect the plug to the mains supply and switch on
the appliance.
Disconnect the device from the power supply, wait
at least 15, release any blocked massage heads,
reconnect and switch on.
10