Hand Switch; Start-Up; Usage - Beurer 64312 Gebrauchsanweisung

Hand switch

7. Start-up

• Remove all protective packaging.
Ensure that the packaging foils do not fall into children's hands. Risk of suffocation.
• Check the device, power supply unit and all cables for damage.
• Position the seat cover on a suitable seat with seating surface and backrest (chair, sofa, or similar). Ensure
that the seat cover is supported over its entire area and has a sufficiently high backrest.
• In order to secure the seat cover, use the flexible tie straps if necessary.
• Connect the power supply unit and car adaptor to the seat cover using the connector.
WARNUNG
• Do not subject the device to any impact and do not drop it.
• Do not use the device if damage is evident to the device itself or any of itsaccessories.
• Use the device only with the power supply unit and adaptor provided, and using only the voltage
specified on the power supply unit.

8. Usage

• Sit comfortably on the seat cover. Take care that you sit centered and your body is in good even contact
with the seat cover.
• Switch on the massage device with the
• Using buttons 2-4, select the area to be massaged and the desired massage intensity. The massage in-
tensity can be set by pressing buttons 2-4 repeatedly (0 = massage off, 1 = intensity level 1, 2 = intensity
level 2). The massage is deactivated if the button is pressed for a third time. The activated massage zones
will be shown by the LED indicators.
• Automatic switch-off is automatically activated when the massage is initiated and is preset to 15 minutes.
• Press the button
• Do not use the massage device for longer than 15 minutes. The massage can be finished at any time by
pressing the button.
• After the massage is finished, disconnect the device from the mains.
Note
• Do not use the massage device just before going to bed. The massage can also have a stimulating
effect and may cause difficulties in getting off to sleep.
WARNING
The massage must be pleasant and relaxing at all times. Stop the massage or change your position
or the contact pressure if you find it is painful or unpleasant.
1
2
3
4
5
6
button.
to switch the heat function on and off in the back area.
1. button with LED indicator
2. Massage intensity button, upper back
3. Massage intensity button, lower back
4. Massage intensity button, bottom
5. button with LED indicator
6. Connection cable to the device
14