Error Codes - SoFlow SO3 2nd GEN Originalbetriebsanleitung

4.3 Operating the turn signal
The control for the turn signals is located on the right-hand side of the handlebar, above the throttle lever. The turn signal lights are located at the respective end of the handlebar. They serve as
an additional signal to indicate a change in direction and are particularly visible from the onset of dusk. Please always drive with foresight and make sure to follow the applicable road traffic
regulations. Bear in mind that these turn signals are a new product feature that is still unknown on the market. The turn signal should be operated in a timely manner before changing direction.
To operate the turn signal, briefly press the L button for (left) or the R button for (right) once. To end the function, briefly press the respective button again. Please keep both your hands on the
handlebars at all times and lean slightly in the opposite direction so that the turn signal is more clearly visible to vehicles behind you. The scooter does not have a hazard warning light function.

4.4 Error codes

The control electronics of your SO3 2nd GEN/ SO3 PRO continuously check the correct function of all important components. If your SO3 2nd GEN/ SO3 PRO detects a malfunction, this is
indicated on the display:
Error message
 E1: Communication failure
 E2: Error with the brake
 E3: Error with the transfer handles
E5: Error with the control

Stop using SO3 2nd GEN/ SO3 PRO immediately if the display shows one of these error messages. Switch the unit off and on again. Check the plug connection between the handlebars and the
front bar that no dirt will affect the contacts of the plugs. Make sure that the battery is fully charged. If the error message still persists, contact the SoFlow service at info@soflow.com.
copyright by www.soflow.com 17