Ice-Cube Production Compartment; Maintenance Defrosting / Cleaning / Changing The Light Bulb - Küppersbusch UKE 145-4 Gebrauchs- Und Montageanleitung

Ice-cube production compartment

Ice-cube production
This appliance is equipped with one or more trays for
the production of ice-cubes.
Fill these trays with water, then put them in the
cube compartment.
Do not use metallic instruments to remove
the trays from the
Maintenance
Unplug the appliance before carrying out
any maintenance operation.
Warning
This appliance contains hydrocarbons in its
cooling unit maintenance and recharging must
therefore only be carried out by authorised
technicians.
Defrosting
¥ During normal operation, the evaporator in the
refrigerator compartment will gradually become
covered with frost.
¥ It is important to periodically
To defrost, proceed as follows:
¥ Turn the thermostat contol knob to the ÇOFFÈ (O)
¥ When defrosting is completed, dry thoroughly and
remove the water collected in the tray. Replace the
stopper.
Turn the thermostat control knob on a medium
position to restart the appliance.
Never use sharp metal tools to scrape off
frost from the evaporator as you could
damage it.
Do not use a mechanical device or any
artificial means to speed up the thawing
process other than those recommended by
the manufacturer.
12
All manuals and user guides at all-guides.com
ice-
ice-cube compartment.
remove the frost.
Cleaning
Never use metal objects for cleaning your
appliance as it may get damaged.
NEVER use detergents, abrasive powders,
highly perfumed cleaning products or wax
polishes to clean the interior as these will
damage the surface and leave a strong
odour.
Clean the inside with warm water and bicarbonate of
soda. Rinse and dry thoroughly.
When the appliance is not in use
Disconnect the appliance from the electricity supply.
Empty all foods and clean the appliance, leaving the
doors ajar to prevent unpleasant smells.
Changing the light bulb
¥ Should the interior light fail to work, first switch off
the appliance and disconnect from the electricity
supply, then replace the
¥ The opening on the diffuser gives access to the
light bulb.
¥ Replace the bulb by other with another with the
same charcteristics.
bulb.