Bestway 58711 Benutzerhandbuch Seite 8

Swivel head does not turn or turn
noticeably slowly
Debris escapes from the robot
Debris leaks outside at the filter cover
Round float sinks
Robot operation lasts shorter than
advertised
Robot cannot be charged / recharged
Side flap does not come up.
Swivel head bottom is jammed
Suction mouth's flap ( at cleaner bottom)
is damaged
Debris clogged at suction mouth and
prevents the flap to close.
Filter cover net is damaged
Float is broken and water leaks in
Battery is not fully charged
Battery is damaged
Charging base is not completely
connected with external adaptor and
robot.
External adaptor is out of order
Check and remove any debris that hinders the movement of the flap.
Detach the swivel head and smoothening-ring in accordance with
instructions of section "How to remove the battery pack" from the
manual, then:
- Remove trapped debris
- Verify the smoothening-ring and bottom plate are installed
correctly (refer to below diagrams)
- Inspect the smoothening-ring for potential damages and wear
and tear. Replace with a new one if necessary
Suction mouth's flap works like a door to prevent the debris from
escaping from the debris compartment.
For assistance, please visit the support section on our website,
www.bestwaycorp.com.
Remove clogged debris from the suction mouth.
Replace with a new filter cover.
For assistance, please visit the support section on our website,
www.bestwaycorp.com.
Replace with a new float.
For assistance, please visit the support section on our website,
www.bestwaycorp.com.
Charge the robot for at least 6 hrs.
For assistance, please visit the support section on our website,
www.bestwaycorp.com.
WARNING! DO NOT replace the battery by yourself. This could result
in severe or fatal injuries and the warranty will be voided as a result.
Make sure that the charger base is connected with external
adaptor and robot properly and completely.
Refer to instruction manual.
For assistance, please visit the support section on our website,
www.bestwaycorp.com.
WARNING! Using the wrong external adaptor will result in
damaging the robot / battery and voiding the warranty as a result.
8