Maintenance; Maintenance Schedule - Husqvarna DE 110 SH Bedienungsanweisung

2. Stop the product, refer to
SH on page 11 or To start and stop DE 110 H/DE
120 H on page 12 .
3. Discard the Longopac bag. Refer to
Longopac bag and prepare a new Longopac bag on
page 14 .
Introduction
WARNING:
occur during the troubleshooting, servicing
and maintenance as the operator must be
in the risk area of the product. The operator
must be careful, make a plan and prepare
the work to prevent accidents.
WARNING:
maintenance, make sure that the motor
switch and the pump switch are in the Off
positions. Disconnect the power cord and
remove the pump cable.
WARNING:
electrician do all checks of the electric
components.
WARNING:
not make a hole in the filter. Risk of dust
dispersion.

Maintenance

Do the filter purge procedure. Refer to
To remove dust particles from the prefil-
ter during operation on page 12 .
Look for signs of wear or damage of the
dust release rubber cone.
Do a check of the power plug and the
power cord.
Look for signs of wear, damage or loose
connections of the controls before the
unit is connected.
Do a check of the hose and the hose
connectors.
Look for signs of wear or damage of the
plastic parts.
Do a check of the lifting eyes.
1587 - 011 - 06.03.2023
To start and stop DE 110
To discard a full
Maintenance
Product related accidents
Before you do
Only let an approved
Make sure that you do
Before
each use
X
X
X
X
X
X
X
4. Clean the product. Refer to
page 16 .
5. Prepare the product for transportation. Refer to
move the product long distances on page 22 .
WARNING:
obey all local regulations to dispose the
dangerous dust correctly, before and during
maintenance.
WARNING:
instructed person, must do a technical
inspection at least annually. The technical
inspection includes an inspection of the
filters for damage, air tightness of the
product and correct function of the
control mechanism. In addition the filtration
efficiency of the product must be tested at
least annually, or more frequently as may
be specified by national requirements. If the
test is not conducted the HEPA filter must be
replaced by a new one.

Maintenance schedule

The maintenance intervals are calculated from daily use
of the product. The intervals change if the product is not
used daily.
Daily Weekly suction is
To clean the product on
Make sure that you
The manufacturer, or an
When Each 6
months or months or
low 600 h
To
Each 12
2000 h
15