Husqvarna DE 110 SH Bedienungsanweisung Seite 13

2. Close the air flow that moves through the air intake
with the air intake plug or the intake valve to make
vacuum.
3. Wait 5 seconds until vacuum is made, then push the
filter purge button. Do this step 3 to 5 times. It is
important to let the product make vacuum between
each button push.
X 3-5
If the suction is not sufficient after this procedure, it is
necessary to clean the prefilter with water. Refer to .
To install a new Longopac bag cassette
CAUTION:
you install a new Longopac cassette. Refer
To remove dust particles from the prefilter
to
during operation on page 12 .
1. Put the Longopac cassette around the inner edge of
the Longopac holder.
2. Remove the 4 straps after you put the Longopac in
the holder.
1587 - 011 - 06.03.2023
Clean the prefilter before
3. Pull the inner layer of the Longopac cassette up (A)
and fold it into the holder (B).
A
4. Attach the Longopac holder to the rear part of the
container (A). Then attach the Longopac holder to
the sides and to the front of the container (B). Push
the Longopac holder up until you hear a solid click.
A
5. Make sure that the Longopac is sealed.
B
B
13