Inhaltsverzeichnis
Werbung
UK
DE
DK
JP
CN
FR
3.2 DALI SPEKTOR 6
the speaker are designed to stand on the floor. SPEKtOr 6 can be used with spikes or rubber
bumpers under the speakers, see figure 3c/D. Be careful not to over tighten the locking nuts.
Spikes or rubber bumpers can improve the sound quality. You can try both to hear what gives
the best sound quality in your setup. Please be aware, that spikes may damage the floor, if it is
not protected by e.g. coins under the spikes.
3.3 DALI SPEKTOR VOKAL
SPEKtOr VOKAL is the dedicated centre channel and has been specially designed to be
positioned close to the large surface of the tV screen. You can place it above or below the
screen, on a stand or on a shelf. We recommend fitting the enclosed bumpers to ensure a
stable, vibration-free setup (see figure 3E).
4 .0 C O N N E C T I O N
correct, tight connections to your amplifier are extremely important for your listening experience.
Always use cables of the same type and length for left and right channels. We recommend using
special speaker cables from DALI, available from your dealer.
connection in correct phase is a detail that is often ignored. the red (+) terminal of the amplifier
must be connected to the red (+) terminal of the loudspeaker. the black (-) terminal of the
amplifier must be connected to the black (-) terminal of the loudspeaker (see figure 4). Even a
single loudspeaker connected out-of-phase in a stereo or surround installation will make the
bass weaker and the stereo image unfocused.
for the optimal listening experience, the right loudspeaker (as seen from the listening position)
must be connected to the amplifier output terminals marked "r" or "right". the left loudspeaker
must be connected to the amplifier output terminals marked "L" or "Left".
NOTE: Before connecting cables or changing any connections, ALWAYS turn off your amplifier.
NOTE: Make sure that the bare conductors are tightly gripped by the terminals with no loose
wires which could cause a short circuit and damage the amplifier (see figure 5).
NOTE: If you are using DALI SPEKtOr in a surround system, follow the instructions included
with your surround amplifier.
5 .0 R u N N I N G - I N
Like any mechanical system, a loudspeaker requires a "running-in" period to perform at its
best. You will experience a gradual increase in sound quality during the first period of use. the
break-in period will vary depending on use and playback volume. You should expect up to 100
hours of playback until maximum performance is reached. unlike other mechanical systems,
the life-span of a loudspeaker is increased by normal, regular playback of music.
6.0 C L E A N I N G A N D M A I N T E N A N C E
clean the cabinets with a soft, dry cloth. If the cabinets are dirty, wipe with a soft cloth dipped in
all-purpose cleaner and then well wrung out. Be very careful when wiping the speaker cones,
as they are very fragile. front grilles can be cleaned with a clothes brush and wiped with a
wellwrung, lint-free cloth and mild all-purpose cleaner.
9
Werbung
Inhaltsverzeichnis
