Inhaltsverzeichnis
Werbung
6.1 AVOID DIRECT SUNLIGHT:
the surfaces of the speakers may fade or become discoloured over time when exposed to
direct sunlight. therefore avoid positioning the speakers in direct sunlight.
7.0 D I S P O SA L
If you want to dispose of this product, do not mix it with general household waste. there is
a separate collection system for used electronic products in accordance with legislation that
requires proper treatment, recovery and recycling. Private households in the Eu member states,
Switzerland, Liechtenstein and Norway may return their used electronic products free of charge
to designated collection facilities or to a retailer (if you purchase a similar new one). If you reside
in countries not mentioned above, please contact your local authorities for the correct method
of disposal. By following this process, you will ensure that your disposed product undergoes
the necessary treatment, recovery and recycling and thus prevent potential negative effects on
the environment and human health.
8.0 P OW E R A N D AC O u ST I C P R E S S u R E
How loud a speaker is able to play and still sound good is completely dependent on the signal
it has to reproduce. So, in practice, it is not possible to define an unequivocal level for use in
comparing different speakers.
Lots of pure, undistorted output from a large amplifier is better than a distorted signal from a
small amplifier stretched beyond its capacity. the signal from a distorting (clipping) amplifier
contains much more high-frequency information than an undistorted signal, and therefore puts
a heavy strain on the tweeter. consequently, speakers are often damaged by small amplifiers,
having to work too hard - and very rarely by large amplifiers, which are practically running idle.
It is worth noting that turning tone controls above the neutral setting significantly burdens
both speakers and amplifier. On a good sound system, tone controls should only be used to
compensate for poor recordings and not to permanently compensate for weaknesses elsewhere
in the system. DALI recommends the tone controls generally be set to the neutral position, and
to achieve your desired sound image through correct positioning of the speakers. Ensuring that
you keep the volume low enough for the sound to remain clear and undistorted will minimize
the strain on both speakers and amplifier.
All DALI loudspeakers are designed with linear impedance for an optimal amplifier load. the
result is a significantly more open and detailed sonic image.
9.0 T H E L I ST E N I N G RO O M
Every room has its own distinctive acoustics, which influence the way we experience sound
from a speaker. the sound you hear consists of direct sound from the speakers and reflected
sound from the floor, ceiling and walls. the latter will affect how you experience the sound.
As a basic rule, try to avoid large, hard and reflective areas in the immediate vicinity of your
loudspeakers as it will typically cause strong reflections, which might disturb the precision and
spatial effect of the sound reproduction. reflection might be suppressed by positioning e.g. a
plant between the speaker and the reflecting surface. Soft items such as carpets, curtains etc.
might help if the sound is too bright. Both the amount and quality of the deep bass depend on
the size and shape of the room, and the position of the speakers. Positioning the speakers near
a side or back wall will accentuate the bass.
A corner location will accentuate it even more, but will also increase the reflections.
10
Werbung
Inhaltsverzeichnis
