Controls And Connectors; Scope Of Delivery; Technical Specifications And Operating Environment - DENTSPLY DeguDent Cercon heat plus P8 Gebrauchsanweisung

3.2 Controls and connectors

The following controls and connectors are available:
• Primary power receptacle (1)
• Power switch ON/OFF (2)
• Rocker switch for lifting/lowering the lifting table (3)
• Control panel (4) with membrane keyboard and display
(see Control panel with membrane keyboard and display)
• Interface power supply with RS 232 interface module via
D-Sub 9-pol plug (5) (only for Service).

3.3 Scope of delivery

The scope of delivery includes:
• Cercon ® heat plus P8 sintering oven
• Power cable
• Instructions for Use
• 1 emergency lowering key for lifting table (7), see Lifting
table, emergency lowering
• 3 sintering trays (8)
Important note: Cercon heat sintering trays may not be
used!
• 3 packs of sintering balls (9)
• 1 exhaust tube (pre-mounted) (10)
• 1 sintering block
3.4 Technical specifi cations and operating environment
Power supply:
Maximum power consumption:
Protection class:
Thermal protection class pursuant to EN 60519-2
without safety control:
Dimensions (W × D × H):
Chamber dimensions (ø × H):
Sintering chamber volume:
Weight:
Deployment:
Ambient temperature:
Humidity:
Noise level:
Sintered material:
Heating elements:
Maximum temperature:
Time to T max :
Heater elements:
Display:
Input device:
Technical description 3
5
1
9
8
220 – 240 V, 50/60 Hz
3.0 kW
IP 20
Class 0
540 x 610 x 745 mm
120 x 130 mm
2 liters
Equipment: Approx. 75 kg
Device including packaging and accessories: Approx. 95 kg
Indoors only, on a non-fl ammable surface
+ 0 till + 40 °C – preferably 20
5 – 90%
< 85 dB(A)
Cercon ® base Zirkonoxid
Made of molybdenum disilicide
1.600 °C
Approximately 90 minutes
Type S
Illuminated LCD
Membrane keyboard
3
2
4
10
7
33