Lipo Battery Charging; Get The Helicopter Ready For Takeoff - Carson EASY TYRANN 225 SPY Betriebsanleitung

LIpo battery cHargIng

the helicopter is fitted with a LiPo battery.
3.7 V LiPo battery.
1. The supplied LiPo battery is stored in the body of the helicopter.
2. Connect the helicopter to the connector of the USB charger. The
indicator on the USB plug goes out and lights up again once the
charging process is complete.
Do not leave the copter or the charger unattended during the
charging process and always disconnect the battery from the
charger after completion! While charging, place the battery and
charger on a fireproof base!

get tHe HeLIcopter reaDy For takeoFF

Now we're good to go! But before liftoff, make sure that you have read this manual through completely.
1
Push the throttle lever fully down and then switch on the trans-
mitter.
3
Now move the throttle lever completely up and then back down.
Now the helicopter is ready to launch.
ON/OFF
2
Switch on the helicopter and place it on a flat surface.
ON/OFF
switch
25 // GB