10. Factory Settings; 11. Types Of Alarm; 12. Modbus Mce-C; 13. Bacnet - DAB MCE-50/C Installations- Und Wartungsanleitungen

10. FACTORY SETTINGS

Regulating mode
Hs (Differential Pressure Set-point)
Fs (Frequency Set-point)
Tmax
Operating mode
Set-point reduction percentage
Twin operating mode
Pump start control

11. TYPES OF ALARM

Alarm Code
e0 - e16; e21
e17 - e19
e20
e22 - e30
e31
e32 - e35
e37
e38
e39 - e40
e42
e43; e44; e45; e54
e46
e55
e56
Table 6: List of Alarms

12. MODBUS MCE-C

The use of the Modbus protocol is allowed, through the installation of the cable kit 60193518 MCE MODBUS CABLE KIT.
For more information, see the webpage

13. BACNET

The use of the Bacnet protocol is allowed, through the installation of a Bacnet-Modbus gateway.
For more information and access to the list of recommended devices, see the web page
Parameter
Alarm Symbol
https://dabpumps.com/mce-c
ENGLISH
= Regulation with constant differential pressure
50% of the max. pump head (see inverter sensitive parameters
set in factory)
90% of the pump rated frequency
50 ºC
auto
50 %
= Alternate every 24h
EXT (from remote signal on input I1).
Alarm Description
Internal Error
Short Circuit
Voltage Error
Voltage Error
Protocol Error
Excess temperature
Low voltage
High voltage
Excess current
Dry operation
Pressure Sensor
Pump Disconnected
Booster mode activated in an operation mode not allowed.
Temperature sensor T error
Temperature sensor T1 error
https://dabpumps.com/mce-c
48
Value