Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Dear Customer,
Congratulations on your choice. We are certain
that this modern, functional and practical device
made with first rate quality materials will fully
satisfy your requirements.
Please read all the sections in this INSTRUCTION
MANUAL before using the hood for the first time
in order to obtain maximum performance from
the device and avoid faults which may arise from
incorrect use as well as minor problem solving.
For optimal performance, the external duct should
not exceed FOUR METRES, have more than two
90 ° angles and its diameter should be at least
Ø120.
Safety Instructions
•Disconnect the device before
performing any work on the
interior, e.g. during cleaning or
maintenance.
•The excessive accumulation of
grease in the hood and metal
filters may cause dripping and fire
risks, therefore it is necessary to
wash the inside of the hood and
the metal filters at least once a
month.
•This device can be used by children
aged 8 and over and persons
with reduced physical, sensory
or mental capabilities or lack of
experience and knowledge, if they
have been given supervision or
proper training in the safe use of
the device and if they understand
the dangers involved. Children
should not play with the device.
Cleaning and maintenance should
be performed by the user and not
by unsupervised children.
All manuals and user guides at all-guides.com
•Check that the power voltage and
•For installation, a connection
•If the power lead is damaged
•Air should not be extracted
frequency match those indicated
on the label located on the inside
of the hood. A suitable earth must
be connected (except for Class
II devices, marked with
technical data plate).
method
isolated
fixed
installation
incorporated, in accordance with
installation regulations (adjusted
to the strength to be endured
and with a minimum opening
between the contacts of 3mm)
under overvoltage category III
conditions, for the emergency
shutdown,
cleaning
replacement. In no event should
the earth pass through this switch.
This switch can be replaced with
a plug if it is accessible in normal
use.
it must be replaced by the
manufacturer,
service or by qualified personnel
in order to avoid potential danger.
by ducts used to expel fumes
from equipment powered by
gas or other fuels.
on the
from
the
should
be
or
light
its
after-sales
Werbung
Inhaltsverzeichnis
