Replacing The Lamp; Troubleshooting - AEG DDE5960B Benutzerinformation

1
2
3. Slightly tilt the front of the filter
downwards (2), then pull.
Repeat the first two steps for all filters.
4. Clean the filters using a sponge with non
abrasive detergents or in a dishwasher.
The dishwasher must be set to a low
temperature and a short cycle. The
grease filter may discolour, it has no
influence on the performance of the
appliance.
5. To mount the filters back follow the first
two steps in reverse order.
Repeat the steps for all filters if applicable.
After closing the cover, the control panel
turns white. The appliance is ready to use.
7.3 Cleaning the charcoal filter
To remove the filter:
1. Remove the grease filters from the
appliance.
Refer to "Cleaning the grease filter" in this
chapter.
2. Remove the clips holding the filter bed
(1), then the filter bed (2).

8. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
2
3. Wash the filter bed in hot water without
using detergent or use a dishwasher.
Set the dishwasher without using rinse
aids or any other detergents. The
dishwasher cannot be filled with dishes.
4. Leave the filter bed to dry or use an oven.
WARNING!
Risk of burns! Refer to safety chapter in
oven user manual.
Set the oven for 10 minutes in the maximum
temperature of 60°C.
5. To install the filter, perform the steps in
reverse order. The filter has to be fully
dried before installing it back into
appliance.
Replace the filter bed every 2 years or when
the cloth is damaged.

7.4 Replacing the lamp

This appliance is supplied with a LED lamp.
This part can be replaced by a technician
only. In case of any malfunction refer to
"Service" in the "Safety Instructions" chapter.
63
1