Replacing The Lamp; Troubleshooting; Environmental Concerns - AEG DPE5660M Benutzerinformation

2. Pull the tabs towards the bottom part of
the filter.
3. Slightly tilt the front of the filter
downwards, then pull.

7. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
7.1 What to do if...
Problem
You cannot activate the appliance.
You cannot activate the appliance.
The lamp does not operate.
The appliance does not absorb
enough vapours.

8. ENVIRONMENTAL CONCERNS

Recycle materials with the symbol
packaging in relevant containers to recycle it.
Help protect the environment and human
health by recycling waste of electrical and
electronic appliances. Do not dispose of
4. To install a new filter, perform the same
In any case, it is necessary to replace the
filters at least every four months.

6.4 Replacing the lamp

This appliance is supplied with a LED lamp
and separate control gear (LED driver).
These parts can be replaced by a technician
only. In case of any malfunction refer to
"Service" in the "Safety Instructions" chapter.
Possible cause
The appliance is not connected to a
power supply or it is connected in‐
correctly.
The fuse is blown.
The lamp is defective.
The motor speed is not adequate to
the appearing vapours.
appliances marked with the symbol
. Put the
the household waste. Return the product to
your local recycling facility or contact your
municipal office.
64
steps in reverse order.
Remedy
Check if the appliance is correctly
connected to the electrical supply.
Make sure that the fuse is the cause
of the malfunction. If the fuse is
blown again and again, contact a
qualified electrician.
Replace the lamp. Refer to the
"Care and Cleaning" chapter.
Change the speed of the motor.
with