Replacing The Lamp; Troubleshooting - AEG DGK6681HM Benutzerinformation

6.4 Replacing the charcoal filter -
optional
WARNING!
Depending on type, filter can be or
cannot be regenerated. Refer to the
leaflet provided with the filter.
To replace the filter:
1. Remove the grease filters from the
appliance.
Refer to "Cleaning the grease filter" in this
chapter.
2. Press the handle of the mounting clip on
the filter panel underneath the hood (1).
1
2

7. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
7.1 What to do if...
Problem
You cannot activate the appliance.
You cannot activate the appliance.
You cannot activate the appliance.
3. Slightly tilt the front of the filter
Repeat the first two steps for all filters.
4. To install a new filter, perform the same
In any case, it is necessary to replace the
filters at least every four months.

6.5 Replacing the lamp

This appliance is supplied with a LED lamp
and separate control gear (LED driver).
These parts can be replaced by a technician
only. In case of any malfunction refer to
"Service" in the "Safety Instructions" chapter.
Possible cause
The appliance is not connected to a
power supply or it is connected in‐
correctly.
The fuse is blown.
Cabinet doors are not aligned with
the cabinet frame.
64
downwards (2), then pull.
steps in reverse order.
Remedy
Check if the appliance is correctly
connected to the electrical supply.
Make sure that the fuse is the cause
of the malfunction. If the fuse is
blown again and again, contact a
qualified electrician.
Align the cabinet doors.