5.2
Setting the operating mode (AG 11 only)
The product is factory-set to the operating mode "Eco".
If you want to operate the product in the operating mode "FailSafe", you
must change the position of the jumper on the PCB.
1. Open the product.
2. Plug the jumper onto the contacts for the operating mode to be set.
Operating mode "Eco"
Fig. 6: Operating mode "Eco" (A) and operating mode "Failsafe" (B)
3. Close the product.
Mounting
A
Operating mode "Failsafe"
B
AG 11 / AG 12
EN
19