Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
• the isolating switch is easily accessible by the customer
Before locating the fixing brackets
The unit should be placed on a stable, smooth surface (use the packaging). Do not
apply force onto the controls protruding from the hob.
Adjusting the bracket position
Fix the hob on the work surface by screw 4 brackets on the bottom case of hob
(see picture) after installation.
A
B
C
Screw
Bracket
Screw hole
Cautions
1. The induction hotplate must be installed by qualified personnel or technicians.
We have professionals at your service. Please never conduct the operation by
yourself.
2. The hob will not be installed directly above a dishwasher, fridge, freezer,
washing machine or clothes dryer, as the humidity may damage the hob
electronics
3.The induction hotplate shall be installed such that better heat radiation can be
ensured to enhance its reliability.
4. The wall and induced heating zone above the table surface shall withstand heat.
5. To avoid any damage, the sandwich layer and adhesive must be resistant to
heat.
D
Bottom case
EN-27
Connecting the hob to the mains power supply
This hob must
be
connected
to
the
Before connecting the hob to the mains power supply, check that:
1.
the domestic wiring system is suitable for the power drawn by the hob.
2.
the voltage corresponds to the value given in the rating plate
3.
the power supply cable sections can withstand the load specified on the rating plate.
To
connect the hob
to
the mains power supply,
devices, as they can cause overheating and fire.
The power supply cable must not touch any hot parts and must be positioned so that its
temperature will not exceed 75˚C at any point.
Check with
an
electrician whether the domestic wiring system
alterations. Any alterations must only be made by a qualified electrician.
The power supply should be connected in compliance with the relevant standard,
or a single-pole circuit breaker. The method of connection is shown below.
•
If
the cable
is
damaged
or
to
be
replaced, the operation must
by after-sale agent with dedicated tools to avoid any accidents.
•
If the appliance is being connected directly to the mains an omnipolar
circuit-breaker must be installed with a minimum opening of 3mm between
contacts.
•
The installer must ensure that the correct electrical connection has
and that it is compliant with safety regulations.
•
The cable must not be bent or compressed.
•
The cable must
be
checked regularly and replaced
only.
mains power supply only
by
a suitably qualified person.
do
not use adapters, reducers,
is
suitable without
be
carried out the
by
authorised technicians
EN
-
28
or
branching
been
made
Werbung
Inhaltsverzeichnis
