AEG ELFAMATIC V 3000 Gebrauchs- Und Montageanweisung Seite 17

3
4
Sensor
Brickwork
installation
Normal brickwork or brickwork with inner insulation:
Sensor body fitted flush with plaster surface or
projecting max. 10 mm above plaster surface.
5
4
6
Heat
insulation
Atmospheric sensor
∅11.5 mm
(drill hole ∅12 mm)
max. 10 mm
Plaster
Single system without
A
group control unit
Central system with
B
group control unit
1
Charging contactor
Time switch for possible
2
reduction
3 Release signal from power
2
supply company, and
operating time control
To further storage
4
heaters
1
5 To further charging
contactors
To further group control
6
units
Concrete Heat insulation
Non-bearing and rear-ventilated facade:
Half of sensor body fitted in air duct.
For the Fitter
Atmospheric sensor
∅11,5 mm
(drill hole ∅12 mm)
Concrete, Eternit, etc.
Air
17