Safety Instructions; Intended Use; Before Driving - AL-KO UA-750-II Montageanleitung

Installation and operating instructions
Please read this document before use. This is essential for safe working and trouble-free handling. Comply with the safety and warning
instructions in this documentation and on the product. This document is a permanent component of the described product, and should
remain with the machine if it is sold to someone else.

Safety instructions

All screws must be re-tightened with the prescribed torques after approx. 50 to 100 km of travel.
When installing or loading the load carrier, always engage the handbrake and secure the vehicle against rolling
No luggage or cargo may protrude beyond the side of the carrier or the vehicle.
Endangerment of other road users must be excluded.
Observe the national and statutory national regulations regarding load.
The lighting and the registration number on the carrier must not be obscured by the
Luggage or bicycles must be securely fixed in place. The centre of gravity of the load should be in the centre of the
This is the responsibility of the driver. Lashing straps can lose their tension due to the effects of travel and weather.
Check that your cargo is firmly seated at regular intervals.
Attaching and loading the load carrier can change the driving behaviour of your vehicle, especially when cornering and on uneven road
surfaces (e.g. when driving over potholes, uneven ground or railway tracks).
Therefore, drive at a speed adapted to the vehicle and load.

Intended use

The load must be stowed safely and secure from falling.
Maximum permitted payload: 80 kg!
Important
As the user of this load carrier, you are responsible for correctly securing the goods being transported. The position of the lashing
straps and other securing measures vary depending on the goods being transported and the weight of the load.
Before driving, check the correct securing of the goods being transported.
The registration number of the vehicle can be concealed by the load carrier or the load. In this case, the registration number must be
repeated on the light bracket.
Installation – Instructions for the specialist workshop
Carry out the installation with at least one other person.
Screw size
M6
M8
M10
M12
Recommended tightening torques for dry, non-greased fastening screws (µ=0.14)
Values that deviate from these are given in special notes.

Before driving

Check the attachment of the transported goods (position, lashing straps, etc.)
Check the attachment of the load carrier to the vehicle
Connect the cable set to the socket of the vehicle
Check the functionality of all lights before driving
Torque strength class 8.8
10 Nm
25 Nm
49 Nm
86 Nm
load.
4 / 32
EN
away.
platform.