Setting/Deleting A Schedule; Setting Secondary Areas - Parkside PMRA 20-Li A1 Originalbetriebsanleitung

GB MT

Setting/deleting a schedule

Setting a schedule
1. If necessary, open the cover (1).
2. Unlock the display (10) with the 4-digit
PIN (factory setting "1111").
3. Press the OK button (7) to enter the
main menu.
4. Use the arrow buttons (6) to select
"Schedule".
5. Select the day you want to set (Mon,
Tue, Wed, Thu, Fri, Sat, Sun) with the
arrow buttons (6).
6. Press the OK button to enter the day
setting.
7. Select the start and end time with the
arrow buttons (6).
Two mowing periods can be set
per day.
8. Press the OK button (7) to confi rm and
the selection returns to the left of the
day.
If you only want to set a mowing
period, return to the day or to
the main menu with the back button
(5).
9. Repeat steps 5.-8. to select the sched-
ule period for each day of the week.
10. Press the OK button (7) to confi rm the
result of this setting.
Deleting a schedule
1. Move the selection with the arrow but-
tons (6) to "All" (top left).
2. Press and hold the back button (5) to
delete the entire schedule for the week.

Setting secondary areas

In highly angular gardens, the area output
can be improved,
by setting secondary starting points. In this
case, several starting points can be select-
ed on the perimeter wire.
60
This allows the robotic lawnmower to
reach areas of your garden that are diffi -
cult to access.
The robotic lawnmower will travel the se-
lected distance along the boundary wire
and start mowing in this area.
You can freely choose 5 further starting
points. To do this, measure the distance
between the charging station and the start-
ing point clockwise along the perimeter
wire. You use the frequency in percent to
determine how often the robotic lawnmow-
er starts its work from the charging station
or from the respective starting points. The
mowing procedure is still chaotic in this
mode.
The secondary starting points are automat-
ically approached during operating hours
and according to schedule.
1. If necessary, open the cover (1).
2. Unlock the display (10) with the 4-digit
PIN (factory setting "1111").
3. Press the OK button (7) to enter the
main menu.
4. Use the arrow buttons (6) to select
"Secondary areas".
5. Press the OK button to select a second-
ary range (Areas). Select the starting
distance "Distance (dst)m" and the
ratio "Percent (pct)%" of the area to be
mowed with the arrow buttons (6) and
press the OK button to confi rm. After
the selection, you automatically return
to the overview of the secondary areas.
6. Repeat step 5 to complete the setting of
each secondary area (Areas).
7. Press the OK button (7) to confi rm the
result of the setting.
The lawn mower travels the distance
"Distance (dst) m" specifi ed by you
along the boundary wire (1 - 500 metres)
and then starts mowing.