Connecting The Charging Station To The Power Adapter; Connecting The Boundary Wire To The Charging Station; Fixing The Charging Station; Inserting/Replacing The Battery - Parkside PMRA 20-Li A1 Originalbetriebsanleitung

GB MT
Paths/roads
The lawn mower can easily cross paths
and roads at ground level.
If there are height differences between the
lawn area and path/road, border off the
path/road with a safety distance of ap-
prox. 40 cm.
Narrow passages
Narrow passages on the bordered lawn
area should be at least 1.2 m wide and no
more than 8 m long (see fi gure
The width of 1.2 m refers to the dis-
tance of the boundary wire. The
boundary wire is crossed by the lawn
mower 0.2 m on both sides when mowing.
Connecting the charging
station to the power
adapter
1. Connect the power adapter (14) to the
charging station (17) via the charging
plug (16) and the charging socket (25).
2. Screw the bushing (24) around the joint
to protect it from moisture.
Connecting the
boundary wire to the
charging station
1. Strip approx. 10-15 mm of both ends
of the boundary wire (11) using cable
strippers.
2. Fold the cover (23) upwards.
3. Connect the wire end of the boundary
wire (11) that runs away from the front
and surrounds the lawn to be mown to
the contact socket (27) marked –.
4. Pass the other end of the boundary
wire (11) through the groove (29) un-
der the charging station (17).
50
5. Connect this end of the wire to the con-
6. Connect the mains plug (15) to the
7. Check the LED (28) on the charging
).

er. This can lead to faults and failures in
the lawn mower's operation.
Secure the charging station and the charg-
ing station bumper (18) with the fi xing
nails (12).
The charging station bumper (18) is fas-
tened to the side of the charging station
outside the restricted lawn area.
The operating range indicator (31) on the
charging station must be located within the
restricted lawn area.
blades to come to a stop. There is a risk of
personal injury.
is damaged! In case of contact with eyes
tact socket (26) marked +.
power supply.
station.
If the LED (28) lights up green, the
boundary wire (11) is connected to the
charging station (17) correctly.
When laying the boundary wire
(11), leave it 0.5 - 1 mm longer
than required to have wire left over
for corrections.
Do not place the "protruding" re-
mains of the boundary wire togeth-
Fixing the charging
station
Inserting/Replacing the
battery
When replacing the battery: Switch
off the device and wait for the
There is a risk of injury from
leaking battery fluid if the battery