Installation - Klarstein VALDOSTA 3.1 Bedienungsanleitung

14

INSTALLATION

Preparation
• You will need gas cylinder and proper regulators under the gas pressure to operate
this gas grill. The regulators should be comply with EN 16129 with current version
and national regulation.
• Connect the hose and regulator to the gas cylinder at the left side of the gas grill.
Keep in mind that the gas cylinder must be kept away from heat and in a safe
position.
The hose should have a diameter of 8-10 mm. The recommended length of the hose
must not exceed 1.5 m. The flexible hose should comply with the relevant standard
and local regulations.
Installation
After purchasing your gas cylinder you will then be ready to set it up with your gas grill.
• When changing the gas cylinder, it shall be carried out away from any source of
ignition.
• Position the gas cylinder on the left side of your gas grill or place it in the gas
cylinder compartment inside the grill, keeping in mind that the bottle must be kept
away from heat and in a safe position.
EN
4
47