Intended Use - Hilti NURON TE 4-22 Original Bedienungsanleitung

3 Description
3.1 Product overview
3.2

Intended use

The product described is a cordless SDS­Plus rotary hammer drill. It is designed for hammer drilling in
concrete and masonry, for drilling in steel, wood and masonry and for driving and removing screws.
For this product, use only Hilti Nuron lithium-ion batteries of the B 22 series. For optimum performance,
•
Hilti recommends the batteries stated in the table at the end of these operating instructions for this
product.
• For these batteries, use only Hilti chargers of the type series stated in the table at the end of these
operating instructions.
3.3 Items supplied
SDS­Plus rotary hammer drill, side handle, grease, depth gauge, operating instructions.
The TE DRS-4⁄6 (01) dust removal module greatly reduces dust emissions and is available as an accessory.
Other system products approved for use with this product can be found at your local Hilti Store or at:
www.hilti.group
3.4 ATC
The product is equipped with the ATC (Active Torque Control) quick-acting electronic cut-out.
If the accessory tool sticks or stalls, the product will suddenly pivot about its own axis in the opposite direction.
ATC detects this sudden pivoting movement of the product and switches the product off immediately.
For ATC to function correctly, the product must be free to pivot.
After an ATC cut-out, switch the product off and then on again.
3.5 Motor protection system
The tool is equipped with a motor protection system. It monitors current consumption and motor temperature
and prevents the product from overheating.
If the motor is overloaded through application of excessive working pressure, the product's performance
drops noticeably or it might stall completely.
If the power tool stalls or slows significantly due to overloading, release the pressure applied to the product
and then allow it to run under no load for approx. 30 seconds.
3.6 Status indicators of the Li­ion battery
Hilti Nuron Li-ion batteries can indicate state of charge, fault messages and the battery's state of health.
20 English
1
Dust cap
@
Tool lock / tool holder
;
Connection for the dust collection module
=
Function selector switch
%
Depth gauge
&
Forward/reverse switch with transport lock
(
Control switch
)
Grip
+
Installation opening for accessories
§
Battery
/
Battery release button
:
Battery status indicator
∙
Connection for the TE DRS­4⁄6 (01) dust re-
$
moval module
Side handle
£
LED lighting
|
2265062
*2265062*