Preparing The Installation - Dometic OVN0250 Montage- Und Bedienungsanleitung

Installing the device
6.2

Preparing the installation

A
NOTICE! Risk of damage
Before drilling any holes, make sure that no electrical cables or other
parts of the vehicle can be damaged by drilling, sawing and filing.
Observe the following before you make the cut-out in the furniture:
• The horizontal installation surface must be level and at right angles to the front of
furniture.
• The installation cut-out in the furniture must be rectangular.
• Combustible materials must be prevented from entering through the existing
ventilation openings in the furniture.
➤ Make a cut-out in the furniture as shown (fig. 3, page 4).
6.3 Oven ventilation using a roof flue
A
NOTICE!
• Use a Truma AK 3 roof flue and Truma flue pipes. These have been
tested and approved for use.
• Do not locate any materials unsuitable for temperatures of above
120 °C near the roof flue or the flue pipe
• Lay the flue duct so that it rises gradually. The installation height of the
flue pipe has to be between 200 mm and 1500 mm
• Keep the surrounding walls and components at a distance of at least
50 mm.
➤ Proceed as follows (fig. 5, page 5 – fig. 8, page 6)
6.4 Fastening the device to the furniture
➤ Fasten the device to the furniture as shown (fig. 9, page 6 – fig. b, page 6).
14
OVN0250, OVG0250
EN