Respekta CH 1295 IXCN Montageanleitung Seite 28

English
The lamp module may only be changed by
qualified personnel.
Disconnect the hood from the electricity.
Remove the grease filters.
Find out the junction box, unscrew the screws on the
junction box cover, then take down the junction box
cover.See pic 1.
Find out the terminal of the light connecting wire and pull
it out. See pic 2.
Way 1. Use a tool or the hand to press the spring splinter
of both sides of LED light to the inside, until the light is
pressed out, see pic 3
Then slightly pull the light connecting wire out, see pic 4.
Apply the reverse procedure to install the light back.
• ILCOS D code for this lamp is:
DBS-2/65-H-120/33
– LED modules –rectangle lamp
– Max wattage: 1×2 W
– Voltage range: AC 110-240V
fi200812atl
Installation- / User's Instruction Cooker hood
17. Replacing the LED Light module
1
4
11
2
3
Technical changes reserved
GB