Update For Currency Changes Or New Issue Of Banknotes - CashConcepts CCE 5000 Bedienungsanleitung

CCE – Cash Concepts Europe GmbH
Kemptener Straße 99 – D-88131 Lindau / Germany
Tel.: +49 (0)8382 – 943 15 – 0 / Fax: +49 (0)8382 – 943 15 – 20
Email: info@cce.gmbh / Web: www.cce.gmbh
Display messages / Notifications
Message
SLANT
CHAINT
DOUBLE
HALF
MG / MG1 / MG2 / MG3
IR
UV
IMAGE / IMAGE 1 / IMAGE 2
WIDTH / PASSWIDTH
TIME 1 / TIME 2
DENO DF
JUDGE
Stacking Pocket Full
Replacing the fuse
The CCE 5000 is protected by a fuse which can be exchanged by you without big expenditure in case of need.
Please switch off the machine before the change of the fuse and pull the net plug from the device. There is mortal danger on
the basis of electric shocks by nonobservance.
Draw off the cover of the fuse and exchange it with an equivalent one. The fastener of the fuse must be pressed after the
change again firmly.
Update on currency changes or new issue of banknotes
The CCE 5000 has an update function, so that new issues of banknotes (eg Euro Series 2) can be processed. For this purpose, a
manual update is necessary. Please inform yourself on our website www.cce.gmbh under the topic FAQ / Service if there are any
updates available. There you can also get a detailed instructions for updating the CCE 5000.
Reason
Banknote tilt
Some banknotes are
connected or overlapped
Half piece or incomplete
banknote
Counterfeit or suspicious
banknote
Some banknotes are
nonconforming in size
Denomination different
Sensor error
Stacker full
Solution
Press "RESET" to continue the counting. Adjust the
pressure of banknotes if this error appears often.
Remove the incomplete banknote and press "RESET"
to continue the counting.
A counterfeited or suspicious banknote was
detected. Remove the banknote and press "RESET" to
continue the counting.
Remove the banknote and press "RESET" to continue
the counting.
Remove the banknote and press "RESET" to continue
the counting.
Remove the banknote and press "RESET" to continue
the counting.
Remove the banknotes from stacker and press
"RESET" to continue the counting.
EN
Page 14