Equalizer; Basic Settings; General - Blaupunkt SANTA CRUZ 370 Bedienungsanleitung

Sound settings | Basic settings

Equalizer

You can adjust the equalizer for all sources.
In the main menu or on the control bar of the current
audio source, press the
The equalizer menu is displayed.
Select a preset equalizer via the buttons.
- Or -
Press the User button to adjust the level of the
available frequency bands according to your prefer-
ences.
Note:
With the [ Reset ] button, you can reset the custom-
ised setting again.
- Or -
Press the Flat button for a linear sound playback.
Press the Loudness button to switch increasing
Next, press .
The setting is stored, the current source is displayed
again.
button.
.

Basic settings

In the settings menu, you can adjust the basic settings
erent functions of the device to your require-
ments.
In the main menu, press the [ Settings ] button.
The settings menu is displayed, the General sub-
menu is activated.
Call up the submenus with the buttons in the lower
area of the settings menu.

General

The following settings are possible:
Radio region – Select the reception region for the radio
reception.
Blackout – If this value is set, the display of the radio is
after 10 or 20 sec. without use.
Dimmer mode – Adjust the display brightness
Beep
TFT calibration – The touchscreen can be calibrated
here.
SWC – The buttons of a connected steering wheel con-
gured here.
Software version – Display of the current software ver-
sion.
Load factory settings – Resets all personalised settings.
37