Makita DLM380 Bedienungsanleitung Seite 10

Fig.15
2. Expand the lower handle to its both sides and
with it expanded in that position pivot it backward
and then fit it in the groove in the deck.
Fig.16
3. Tighten the clamping screws on both sides to
secure the lower handle.
Fig.17
4. Raise the upper handle and align the screw holes
in the upper handle with those in the lower handle.
Secure them with the supplied screws, curl
washers and clamping nuts.
NOTE:
At this time, keep a firm grip on the upper handle
•
so that it does not drop off your hand.
Fig.18
NOTE:
Install the upper handle so that the direction of the
•
upper handle and the power supply cord are
positioned as shown in the figure.
Removing or installing the blade
WARNING:
Always remove the lock key and battery cartridge when
•
removing or installing the blade. Failure to remove the
lock key and battery cartridge may cause a serious injury.
The blade coasts for a few seconds after releasing
•
the switch. Make sure that the blade has come to
a complete stop.
Always wear gloves when handling the blade.
•
Fig.19
1. Put the mower on its side so that the mowing
height adjusting lever is placed on the upper side.
2. To lock the blade, insert a lumber or similar into the mower.
3. Loosen the bolt counterclockwise with the box wrench.
Fig.20
4. Remove the bolt, spring washer, flat washer, and
blade in order.
To install the blade, take the blade removal procedure in
reverse.
WARNING:
Install blade carefully as they have a top/bottom facing.
•
Tighten the bolt clockwise firmly to secure the blade.
•
Put the blade so that the blade side with a
•
rotational direction arrow faces outward.
Make sure that the blade is installed securely.
•
Installing the grass basket
Remove the lock key.
Fig.21
Raise the rear guard of the mower unit.
1. Groove
2. Hook
3. Grass basket
015664
Hook the grass basket on the groove of the mower unit.
OPERATION
Mowing
WARNING:
Before mowing, clear away sticks and stones from
•
mowing area. Furthermore, clear away any weeds
from mowing area in advance.
Always wear the safety goggles or safety glasses
•
with side shields when operating the mower.
Firmly hold the lawn mower handle with both hands
when mowing.
The width between the middle of the front wheels shows
the guideline of the mowing range. For even mowing,
overlap the mowing area partially to the previous
mowed area.
Periodically check the level of the grass basket, and
empty before it becomes full. Before every periodical
check, be sure to stop the mower and remove the lock
key and the battery cartridge.
NOTE:
Using the lawn mower with the grass basket full
•
prevents smooth blade rotation and places an extra
load on the motor, which may cause breakdown.
Mowing a long-grass lawn
Fig.22
Do not try to cut long grass all in one go. Instead, mow
the lawn in stages, leaving it for a day or two between
mows, until the lawn is evenly short.
NOTE:
Mowing long grass to a short length all in one go
•
may cause the grass to die and/or block up the
inside of the main unit.
Emptying the grass basket
WARNING:
To reduce a risk of accident, regularly check the
•
grass basket for any damage or weakened
strength and replace it if necessary.
1. Release the switch lever.
2. Remove the lock key.
10
2
3
1