Safety Instructions - Ferm ETM1002 Gebrauchsanweisung

GB
2.

SAFETY INSTRUCTIONS

D
Explanation of the symbols
NL
Carefully read the instructions.
F
In accordance with essential applicable safety standards of European
directives.
E
Class II machine – Double insulation – You don't need any earthed plug.
P
Denotes risk of personal injury, loss of life or damage to the tool in case of non-
observance of the instructions in this manual.
I
Indicates the presence of an electrical voltage.
S
Immediately unplug the plug from the mains electricity in the case that the cord
gets damaged and during maintenance.
FIN
Wear eye protection.
N
Faulty and/or discarded electrical or electronic apparatus have to be collected
at the appropriate recycling locations.
DK
Specific safety instructions
Before using the tacker
• Check the following points:
• Do the voltage of the engine and the engine safe-guard, if any, correspond to the
mains voltage (appliances for a mains voltage of 230 V);
• Are the mains lead and the mains plug in a good condition: solid, without any
loose ends or damage.
• Always wear eye protection when using the tool.
• Maintain the tool with care.
• Check for misalignment or binding of moving parts, breakage of parts, and any other
condition that may affect the tools operation. If damaged, have the tool serviced
before using.
• Check if the slide cartridge has been fastened properly.
• Do not use the tool in a humid environment.
• Do not use the tool on materials containing asbestos.
Using the tool
• Do not use the tool if the switch does not turn it "ON" or "OFF".
4
Ferm Ferm
GB
D
NL
F
E
P
I
S
FIN
N
DK
69