Ferm ETM1002 Gebrauchsanweisung Seite 7

GB
3. BRUG
D
Brugsområde
Fig. 2
NL
Brug til dette redskab en af de følgende typer hæfteklammer eller søm:
• U: 6, 8, 10, 12, 13 eller 14 mm
• T: 14 mm
F
• I: 14 mm
Passende hæfteklammer og søm leveres af Esco, Rapid, Novus og Wolfcraft.
E
Ladning af hæftemaskinen
P
Før åbningen af redskabet, forsikre Dem om at at redskabet ikke er sluttet til
strømforsyningen.
I
For at lade hæftemaskinen
S Fig. 3 - 5
Åbning af glideren
• Drej metalpladen bagved bort fra glideren for at åbne for glideren
FIN
Placering af hæfteklammer
• Tag glideren ud af maskinen.
N
• Placer hæfteklammerne eller sømmene i magasinet
Placering af hæfteklammer
DK
• Sæt glideren tilbage I redskabet.
• Lås glideren fast ved at fæstne metalpladen bagved.
For at bruge hæftemaskinen
Fig. 6 - 8
Placering af redskabet
• Tryk redskabet fast ned.
Tryk sikkerhedspalen ind
• Tryk sikkerhedspalen ind og hold den i trykket ind
Hæftning
• Tryk på kontakten
Redskabet vil give et tilbageslag på grund af den kraft det arbejder med. Husk
på det.
66
• In case a staple or nail
is jammed in the tool,
follow the procedure
below
Repairs and servicing should only be carried out by a qualified technician or
service firm.
Cleaning
Regularly clean the device's casing with a soft cloth, preferably after each use. Keep the
fan slits free of dust and dirt. Remove stubborn dirt using a soft cloth, dampened with
soapy water. Do not use solvents such as benzene, alcohol, ammonia, etc., which might
damage the plastic parts.
Defects
If a defect appears due to a part wearing out, please contact the service center on the
warranty card. At the end of these instructions there is an exhaustive overview of the parts
that can be ordered.
Environment
To prevent damage during transport, the appliance is delivered in a solid packaging which
consists largely of reusable material. Therefore please make use of options for recycling
the packaging.
Damaged and/or disposed of electrical or electronic devices must be dropped
off at recycling stations intended for that purpose.
Warranty
Read the warranty conditions on the separately supplied warranty card.
Ferm Ferm
• Disconnect the tool. • Carefully remove the
staple or nail from the
tool with a thin object
(for example a knife).
GB
D
NL
F
E
P
I
S
FIN
N
DK
7