Ferm ETM1002 Gebrauchsanweisung Seite 5

GB
CE
KONFORMITETSERKLÆRING (DK)
D
Vi erklærer under almindeligt ansvar, at dette
NL
er i overensstemmelse med følgende standarder eller normative dokumenter:
EN50144-1, EN50144-2-16, EN51044-1, EN51044-2, EN61000-3-2, EN61000-3-3
F
i overenstemmelse med direktivreglerne
E
98/37/EC, 73/23/EEC, 89/336/EEC, 2002/95/EC, 2002/96/EC
Fra 01-10-2006
P
ZWOLLE NL
I
S
J.A. Bakker - van Ingen
CEO Ferm BV
FIN
Vores firmapolitik bygger på løbende forbedring af vores produkter, og vi forbeholder os retten
til at ændre produktspecifikationer uden varsel.
N
Ferm BV • Lingenstraat 6 • 8028 PM Zwolle • Holland
DK
68
FET-200
J. Lodewijk
Quality Manager Ferm Global
• Always hold the tool with two hands while starting.
• Always keep the cord away from the moving parts of the machine.
• Keep your hands away from the work piece.
• In the case of jamming by a nail or staple, switch the machine off immediately and
remove the plug from the mains.
• Never aim the tool at people or animals.
• Use only staples or nails fit for this tool.
• Make sure not to damage any leads when using the tool.
Electrical safety
When using electric machines always observe the safety regulations applicable in your
country to reduce the risk of fire, electric shock and personal injury. Read the following
safety instructions and also the enclosed safety instructions.
Always check that the power supply corresponds to the voltage on the rating
plate.
Class ll machine. Your machine is double insulated; therefore no earthwire is
required.
Replacing cables or plugs
Immediately throw away old cables or plugs when they have been replaced by new ones.
It is dangerous to insert the plug of a loose cable in the wall outlet.
Using extension cables
Only use an approved extension cable suitable for the power input of the machine. The
minimum conductor size is 1.5 mm
completely.
3. USE
Application
Fig. 2
For this tool, use one of the following types staples or nails:
• U: 6, 8, 10, 12, 13 or 14 mm
• T: 14 mm
• I: 14 mm
Suitable staples and nails are provided by Esco, Rapid, Novus and Wolfcraft.
Loading the tacker
Before opening the tool, make sure the tool is disconnected.
Ferm Ferm
2
. When using a cable reel always unwind the reel
GB
D
NL
F
E
P
I
S
FIN
N
DK
5