Adding More Laundry; Interrupting The Programme; Programme End; Removing The Laundry - Schulthess Spirit topLine TW 8410 Bedienungsanleitung

Adding more laundry

This is possible at any time.
X Press the door open button.
 Wait for the drum to stop.
X Add your laundry.
X Close the door again.
X Press the start button.
If the child lock is activated:
X Hold the start button down.
X Simultaneously tip the fast forward button.
 The drying process is continued.

Interrupting the programme

X Interrupt the programme by pressing the fast forward
button repeatedly, until «Programme end» appears on
the display.
If the child lock is activated:
X Hold the start button down.
X Simultaneously tip the fast forward button.

Programme end

The programme end is indicated by the display value
«00:00h», the display of «Programme end» as well as a
flashing control light.
 An audible signal (only if summer function is switched
on).
 The drum continues to rotate periodically after the
programme has ended to prevent the laundry from
creasing (only if crease protection has been switched on,
for 30 or 60 minutes).
The washing should be taken out now at the latest.
Remove the laundry
X Press the «Open door» button.
 The drum light comes on.
X Remove the laundry.
X Clean the filters.
58

Cleaning the filters

When fabrics are used, the fibres are rubbed (laundry
fluff), which are released when the fabrics are dried, col-
lecting in the filter in the door opening.
The inner, fine filter (A) must therefore be cleaned after
each drying process.
Cleaning the filter A / Clean after every drying
programme
X Press the «Open door» button..
X Pull out the inner, fine filter and swing it open.
X Rub your hand over the filter and remove the fluff.
It may happen that a supposedly proper cleaned fil-
ter becomes impermeable, due to a fine, invisible coat
remaining in the filter meshes.
X Hold the filter with one flat surface up wards and pour
a little water on to it. If it is impermeable, clean the filter
with a brush under running water.
 If the coat cannot be brushed away, a commercial
descaler spray must be used to dissolve it.
X Spray the descaler on the entire filter surface and
leave it to take effect. In case of stubborn coats place
one layer of kitchen roll onto the filter surface and spray
descaler on it to ensure the filter is moist. Leave the
descaler to take effect overnight. Then clean the filter
under running water with a fine brush.