BOMANN VS 7329 Bedienungsanleitung, Garantie Seite 26

also prevents unpleasant odors and mold growth, as
the appliance is not switched off completely.
The corresponding symbol indicates the activation.
Keep pressing the VACATION button again for about
3 seconds to deactivate the vacation mode.
Key lock
Keep pressing the LOCK button for approx. 3 sec-
onds to unlock the control panel for operation.
The control panel locks automatically about 25 sec-
onds after the last button was pressed.
The corresponding symbol indicates the activation.
Alarm
As soon as the appliance door remains open for
more than 90 seconds, an alarm sounds.
Press the ALARM button or close the appliance door
to stop the alarm.
If the appliance door remains open for more than
10 minutes, the interior light of the appliance turns
out.
Settings
➨ Basically, the temperature changes depending on
the ambient temperature (place of installation), the
frequency of opening the door and the equipment.
or initial operation, first set the lowest possible inter-
nal temperature (= highest power level) or activate
the super cooling function until the appliance has
reached the desired operating temperature. It is rec-
ommended to reset to a medium power level after-
wards, then you can easily make any temperature
correction.
➨ Recommendation, for optimized food storage and
to avoid food waste, a medium power level is gener-
ally best. A high power level also increases energy
consumption.
The recommended temperature in the center of the
fridge is approx. 4∼7 degrees. If the temperature in
the center is correct, the different zones usually also
have the correct temperature.
Interior light
When opening the appliance door, the interior light
will turn on automatically.
Equipment
Note that the equipment varies depending on the
appliance type.
The various shelves and drawers can be height-
adjusted (partially and model-dependent) or removed
for individual storage. Practical also for cleaning pur-
poses.
NOTE:
For the most efficient use of energy, place all
shelves/drawers in their original positions.
Removing / inserting the shelves
• To remove, open the unit door completely, lift the
shelf, if necessary, slant slightly and pull it out to
the front.
• Safely reinsert the shelf at the desired height and
push it in until the stop is reached.
Removing / inserting the door racks
• To remove the door rack, press it upwards out of
the retainer or, depending on the model, first
press one side inwards until this side can be
pulled out upwards.
26