Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Charging the Unit
•
Turn the unit off.
•
Connect the power adaptor connector with one
of the following jacks.
▪
The socket directly at the bottom end of the
unit.
▪
Alternatively place the unit in the charging
station. The socket is at the rear.
•
Plug the power adaptor into a 230V/50Hz wall
outlet.
•
The charge indicator turns on during charging.
Note:
The charge indicator does not indicate the
state of charge of the rechargeable battery.
•
Charge the unit before first use for 10 hours.
•
Later charges take 10 hours as well.
Note:
The unit cannot be operated with mains power.
Caution:
After 10 hours always disconnect from mains
power supply.
Note Lifetime Rechargeable Battery
You can extent the lifetime of the rechargeable
battery by following these steps:
►
Only charge after the battery is nearly
exhausted.
►
Do not charge for more than 10 hours.
►
Charge the unit at temperatures between
0° and + 40°C.
Clip and Cut Beard
•
Select the cutting length with the attachment
comb. Press and slide the button (3).
•
Slide the switch (4) towards the clipper head:
Start with the longest cutting stage and clip
goatee, sideburns or full beard step by step to
the desired length.
Clip Hair
•
Select the cutting length with the attachment
comb. Press and slide the button (3).
•
Slide the switch (4) towards the clipper head:
Start with the longest cutting stage and clip
your hair step by step to the desired length.
Outlining and Shaving the Neck
•
Remove the attachment comb (1) and slide the
switch (4) towards the clipper head.
•
The clipper head allows precise outlining the
shape of the beard, even in difficult to reach
places as well as a clean shaving of the hair-
line at the neck.
Finish Operation
Slide the switch (4) down.
Cleaning and Maintenance
•
Regular cleaning and maintenance ensures
optimum results and long lifetime.
•
Turn the unit off and disconnect from mains
power supply, if necessary.
Warning:
►
Do not submerge the unit in water.
Caution:
►
Do not use a wire brush or other abrasives.
►
Do not use sharp or abrasive cleaning
agents.
•
Use the cleaning brush to remove remaining
hair after use.
•
Remove the attachment comb (1).
•
Press the two buttons (2) at the rear of the unit
to fold out the clipper head.
•
Regularly apply 1 - 2 drops acid-free oil to the
clipper head.
•
Fold the clipper head back after cleaning until
it locks in place.
•
Clean the casing with a slightly damp cloth, if
necessary.
•
Replace the attachment comb.
Noise emission
The workplace-related emission value is less
than 70 dB(A).
Technical Specifications
Model: .............................................HSM/R 5607
Power supply adaptor: ...............230V, 50Hz, 3 W
Output power adaptor: ...............DC 4.5V, 150mA
Protection class power adaptor: ........................ ΙI
Rechargeable battery: ...................1.2V, 800mAh
Run time: ................................... max. 35 minutes
Charging time battery: ........................... 10 hours
Net weight: .............................................0.140 kg
Subject to change without prior notice!
7
Werbung
Inhaltsverzeichnis
