Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
8 Operation
8.1 Switching the appliance on
In order to switch on the appliance push the mains plug into the socket.
8.2 Setting the temperature (Manuell)
The temperature can be set at from 0°C to 10°C with
slotted screwdriver can be adjusted.
The setting is made via the rotary knob.
Our recommendation is about 4°C.
This corresponds to a setting with the numbering 3-4 .
Setting the temperature (Digital)
Press and hold the SET button for approximately
4 seconds until the display reads the factory pre
set setting 4°C.
To change temperature setting, press the
▲ (UP) or ▼ (DOWN) arrow key to select
the desired setting
Press the SET button again to accept new setting.
The electronic controller has been factory set to maintain
temperature at approximately 4°C under normal ambient conditions.
LIGHT SWITCH (Lig): The LED lights can be turned on or off by
depressing the "Lig" button.
MANUAL DEFROST: Press the "def" button 4s, cooler goes into defrost mode.
Unit will automatically return to operating mode when defrost cycle has been
completed.
ECO: Press "ECO" button 2S to enter "ECO" mode
32
NOTE
Please note that the temperature will change depending on the ambient
temperature (installation site), the frequency of opening the door and the
fittings. Please note the best before date of the products.
IMPORTANT
High room temperatures (such as e.g. on hot summer days) and a cold
temperature setting can lead to continuous refrigerator operation.
The reason for this is that the compressor has to run continuously in order
to maintain the low temperature in the appliance. The appliance is not able
to defrost automatically because this is only possible when the compressor
is not running (see the defrosting section). Therefore, a thick layer of frost or
ice may form on the rear interior wall.
8.3 Noises during operation
Normal noises
• Humming – the noise is caused by the compressor during operation.
It is loud when it switches on or off.
• Liquid noise – caused by the refrigerant circulating in the unit.
• Clicking noises – the temperature regulator switches the compressor
on or off.
9 Defrosting / Switching off
During the cooling and defrosting phases a thin layer of ice or drops of water
form on the inner wall. The condensation water flows into a collecting tray and
evaporates. Please ensure that the outflow channel is not blocked. It can be
cleaned carefully with a pipe cleaner or a small brush.
Your refrigerator does have automatic defrosting, but if a thicker layer of ice
forms in-side the appliance – if you occasionally defrost it by hand – proceed
as described under point 10.1. Optionally, in order to accelerate defrosting you
can place a bowl with hot water in the appliance or use a hairdryer.
33
Werbung
Inhaltsverzeichnis
